Enterasys 2200 Installation & User Manual page 43

Table 4-2 Troubleshooting Checklist (Continued)
Problem
No Local
Management
Password screen.
Cannot navigate
beyond Password
screen.
Possible Cause
Autobaud is enabled, but
the baud rate has not yet
been detected.
Terminal setup is not
correct.
Improper console cable
pinouts.
Corrupt firmware image,
or hardware fault.
Improper Community
Names Table.
Recommended Action
Press ENTER (RETURN) (may take up to
four times).
Refer to the SmartSwitch Series 2E253,
2H252, 2H253, and 2H258 Local
Management User's Guide for proper setup
procedures.
Refer to Appendix A
pinouts.
If possible, attempt to download the image to
the 2H258-17R again. Refer to
instructions to clear NVRAM.
1. Refer to the SmartSwitch Series 2E253,
2H252, 2H253, and 2H258 Local
Management User's Guide for Community
Names Table setup.
2. If you have forgotten the Community
Names, refer to Appendix B
instructions on how to set the mode switch
to reset the Community Names to their
default values.
Troubleshooting Checklist
for proper console port
Section B
for
Troubleshooting
for
4-5