Table of Contents
Advertisement
Figure I showsthe s nowthrower
in the shippingposition.
Figure2 showsthesnowthrowercompletely assembled.
Reference to the right and left hand side of the sndw
thrower isfrom the operator's position at the handle.
TO REMOVE
SNOW
THROWER
FROM CARTON (See Fig 1)
•
Remove top pallet and discard.
•
Cut all four comers of the carton from top to bottom
and lay the panels fiat.
•
Cut the cable ties attached to the auger.
•
Cut and discardthe plasticties that securethecrank
assembly and place the assembly aside.
•
Removethe packing materialfromthe controlpanel.
•
Cut and discard the packing securing the clutch
cables to the lower handle.
With two 9t16 inch wrenches, loosen (do not
remove) both bolts securing the upper and lower
handles. Swingthe upperhandle intothe operating
position.
NOTE: ifthe cables havebecome disconnectedfrom the
clutch levers, reinstallthe cables as shown in Figure3.
•
Tighten bothbolts securely.
Roll the snow thrower off the skid by pullingon the
handle.
NOTE: This snow thrower is equipped with a track drive
and can be hardto pushwhen the engine is not running.
It iseasier to pullthe snowthrower backward ifit mustbe
moved withoutthe engine running.
The drive system may be tight when you first use your
snow thrower. It loosens up as you use it.
HOW TO SET UP YOUR SNOW
THROWER
•
For packing,the height adjustskids were mounted
with the bottom lip tumed inward. Remove skid
mounting nuts (Fig. 2) and remount withthe lip
outward.
To adjustthe skidheightfordifferent conditions,see
To Adjust Skids Heights paragraph on page 18.
CAUTION:
IF YOU ARE REMOVING
A
SNOW FROM ANY ROCKY OR UNEVEN
SURFACES, RAISE THE FRONT OF THE
SNOW THROWER
BY MOVING THE
SKIDS DOWN. THIS WILL HELP TO PREVENT
ROCKS AND OTHER DEBRIS
FROM BEING
PICKED UP AND THROWN BY THE AUGER.
LOWER HANDLE
CRANK
CLUTCH
CABLE
FIG. 1
UPPER
HANDLE
. ASSEMBLY
FIG. 2
im
i
DRIVE
LEVER
FIG. 3
7
Hide quick links:
Advertisement
Table of Contents
