Configuring A Workgroup - Enterasys FN 100 User Manual

Workgroup Configuration
You can view and modify existing work groups as well as configure new work
groups from this window. The Workgroup Table at the top of the window lists
each existing work group along with its configuration information. The
Add/Modify section of this window allows you to set-up the parameters of your
work group, including Name and Type. The Ports in Workgroup section of the
window allows you to choose the ports that will be included in the workgroup.
The IP Address, IP Mask, and IPX Network fields in the Add/Modify section of the
Virtual Workgroups window are not applicable to the FN100 and are therefore grayed out.
NOTE
Though they may not appear this way upon opening the window, once you select a Type
of workgroup (see step #3 below), these fields will go gray.

Configuring a Workgroup

To add or modify a workgroup using the Virtual Workgroups window:
1. To modify an existing workgroup, click on the desired entry in the Workgroup
2. Type a name in the Name field in the Add/Modify portion of this window. The
5-2
Figure 5-1. Virtual Workgroups Window
Table. The selected workgroup's configuration information will be reflected in
the Add/Modify and Ports in Workgroup sections of the window.
name can be 1-16 alphanumeric characters. You will use the name to identify
the workgroup.
Configuring a Workgroup