Specifications; Functional Description; Operation - Milwaukee 2601-20 Operator's Manual

• lead from lead-based paint
• crystalline silica from bricks and cement
and other masonry products, and
• arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this
type of work. To reduce your exposure
to these chemicals: work in a well ven-
tilated area, and work with approved
safety equipment, such as those dust
masks that are specially designed to
fi lter out microscopic particles.
6. Keep hands away from all cutting
edges and moving parts.
Specifi cations
Volts No Load
Cat. No. DC RPM Steel
1/2"
2601-20 18 * Low 0 - 350
High 0 - 1 400 1/2"
* Cat. No. 2601-20 is not compatible with V™-technology or NiCd systems.

FUNCTIONAL DESCRIPTION

1
1. Keyless chuck
7
2. Torque selector collar
3. Speed selector
4. Tool holder
5. Trigger
6. Control switch
7. LED
Symbology
Direct Current
Underwriters
Laboratories, Inc.,
United States and
Canada
No Load Revolutions
per Minute (RPM)
Capacities
Flat Bit Auger Bit Hole Saw Screws (dia.)
1-1/8" 1" 2-1/8" 1/4"
1-1/8" N/A 2-1/8" 1/4"
2
3
6
5
4
Recharge only with the charger
specifi ed for the battery. For spe-
cifi c charging instructions, read the
operator's manual supplied with
your charger and battery. This tool is
not compatible with V™-technology
or NiCd systems.
Always lock trigger or remove
battery before changing or removing
accessories. Only use accessories
specifi cally recommended for this
tool. Others may be hazardous.
To reduce the risk of injury, wear
safety goggles or glasses with side
shields.
Using Keyless Chucks
This tool is equipped with a spindle lock. The
chuck can be tightened with one hand, creat-
ing higher grip strengths on the bit.
Always remove the battery pack or lock the
trigger before inserting or removing bits.
Fig. 1
4
Sleeve
ASSEMBLY
WARNING
Inserting/Removing Battery Pack
Insert the battery pack from the front by
sliding battery pack into the body of the
tool. Insert the battery pack until the battery
latches lock. To remove the battery pack,
press in both battery latches and slide the
battery pack off of the tool.

OPERATION

WARNING
1. To open the chuck jaws, turn the sleeve
in the counterclockwise direction.
When using drill bits, allow the bit to
strike the bottom of the chuck. Center
the bit in the chuck jaws and lift it about
1/16" off of the bottom.
When using screwdriver bits, insert the
bit far enough for the chuck jaws to grip
the hex of the bit.
WARNING
2. To close the chuck jaws, turn the sleeve
in the clockwise direction. The bit is se-
cure when the chuck makes a ratcheting
sound and the sleeve can not be rotated
any further.
3. To remove the bit, turn the sleeve in the
counterclockwise direction.
NOTE: A ratcheting sound may be heard
when the chuck is opened or closed. This
noise is part of the locking feature, and
does not indicate a problem with the chuck's
operation.
5