Installing Module Into Matrix N1, N3, Or N5 Chassis - Enterasys Matrix 2G4082-25 Hardware Installation Manual

Installing Module into Matrix N1, N3, or N5 Chassis

The 2G4082‐25 can be installed in the single slot of the Matrix N1 chassis, or any available chassis
slot in the Matrix N3 chassis (slots 1 through 3) , or Matrix N5 chassis (slots 1 through 5). These
chassis have horizontal slots for DFE‐Series modules. To install the module into the Matrix N1,
N3, or N5 chassis,
Matrix E7 or N7 Chassis" on page 3‐2.
Caution: Failure to observe static safety precautions could cause damage to the DFE module.
Follow static safety handling rules and wear the antistatic wrist strap.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the board or
components can cause damage.
Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de
electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad para la
manipulación del producto y no olvide utilizar la pulsera antiestática.
No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto cortante
entra en contacto con la placa o con los componentes, éstos podrían dañarse.
Note: The DFE-Platinum 2G4082-25 module can be installed in the single-slot of the Matrix N1
chassis, or in any slot of the Matrix E7, Matrix N7, Matrix N5, or Matrix N3, but does not have FTM
connectivity.
When installed in the Matrix E7, Matrix N7, Matrix N5, or Matrix N3, the 2G4082-25 will boot as a
standalone device with no connectivity to other modules in the chassis.
refer to Figure 3‐2 and proceed as described in "Installing Module into
Caution: When setting the locking levers to the closed position, do not try to force the locking levers
to the point that they touch the face of the front panel. Forcing the locking levers to this point could
damage the module and chassis.
Precaución: Al mover las palancas a la posición de cerrado, tenga cuidado de no llevarlas a un
punto en donde estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo o el
chasis.
Installing Module into Matrix N1, N3, or N5 Chassis
Matrix DFE-Platinum Series Installation Guide 3-5