Camera Setting - EverFocus EFD300 Operation Instructions Manual

You can lose the camera fixing screw and tilt the camera to your best angle of view.
Tilt

3. Camera Setting

CAMERA SETTING
BLC (Back Light Compensation)
When BLC is turned on, the AGC, FL and IRIS operating point is determined by averaging over
the center area instead of entire field-of-view, so that a dimly-lit foreground object at center area
can be clearly distinguished from brightly-lit backgrounds. BLC should not be used unless it is
needed to compensate for back-light.
The default setting is OFF. For Auto-Iris lens model, the brightness can also be adjusted via the
Iris level control VR.
AGC (Automatic Gain Control)
AGC ON: The sensitivity increases automatically when light is low.
AGC OFF: A-low-noise picture is obtained under a low light condition.
The default setting is ON.
FL (Flickerless)
When picture flicker fiercely, turn FL on, then the camera will stabilize the speed of electronic
shutter at 1/100(S)(NTSC) or 1/120(S)(PAL) automatically, and reduce the flicker immediately.
The default setting is OFF.
IRIS Level Control (For Vari-Focal Lens Model)
Brightness Level can be adjusted from the IRIS level VR while using the direct drive lens.
•Turn counterclockwise to L to get darker picture.
•Turn clockwise to H to get brighter picture. Electronic Shutter (For Fixed Lens Model)
Camera Fixing Screws
7