Maintenance & Care - Bissell AeroSwift™ Compact Vacuum User Manual

Maintenance & Care
Quick tips
To maximize your cleaning performance and
extend the life of your vacuum, it is important
that you empty your dirt bin and clean your
filters frequently.
1. empty the dirt container when debris reaches
the "full" line. For best performance, empty after
each use.
2. Check the foam filter located in lower filter
tray and clear out any dirt and debris before
vacuuming. Wash with cold water or replace
as needed.
3. Check rotating brush and belt for wear and
tear at least once a month.
Empty Dirt bin:
The dirt bin should be emptied before debris
reaches the "full" line. The dirt bin is designed
with a bottom empty release for less mess
emptying.
1. Unplug the vacuum from electrical outlet.
2. Push the tank release button located on the
front of the base of the unit above the carrying
handle.
3. Grasp the carrying handle and carry the dirt
bin to a garbage/waste bin.
4. With the dirt bin over a garbage/waste bin,
push the empty release button located on the
lower backside of the dirt bin to release the dirt.
notE: It may be necessary to gently tap the
side of the bin against the garbage/waste bin
to knock out any dirt or debris in the upper
portion of the dirt bin.
5. When empty, close the bottom lid and it will
lock into place.
6. Connect the dirt bin back onto the vacuum by
fitting the bottom of the dirt bin into the vacuum
base and then line up the carrying handle to fit
under the dirt bin release tab. The handle will
snap into place to secure.
notE: make sure the power cord does not
interfere with connecting the dirt bin back
into base.
www.bissell.com
8
800.237.7691
WaRnInG
To reduce the risk of electric shock, turn power switch off
and disconnect polarized plug from electrical outlet before
performing maintenance or troubleshooting checks.
2. 4.
5. 6.