Table of Contents
Advertisement
2.6.2
Removing the HDD module cage
1.
Disconnect the all cables from the SATA/SAS backplane on the HDD module
cage.
2.
Level the HDD module cage latch
counterclockwise. The HDD module
cage will be pushed out of the
chassis.
3.
Completely pull out the HDD module
cage.
2.6.3
Installing a hot-swap SATA/SAS hard disk drive
1.
Release a drive tray by pushing the
spring lock to the right, and then
pulling the tray lever outward. The
drive tray ejects slightly after you
pull out the lever.
2-14
2
Chapter 2: Hardware setup
Advertisement
Table of Contents
