Adjusting Table Angle; Adjusting Belt Assembly Position; Horizontal Belt Sanding With Work Stop; Abrasive Belt Sanding - Craftsman 351.225930 Operator's Manual

\
Tracking Nut
Tension Lever
/
Figure 10 - Adjusting Belt Tracking
ADJUSTING BELT ASSEMBLY POSITION
Refer to Figure 11.
Sanding belt assembly can be adjusted from vertical to
horizontal position, or any angle in between.
• Loosen socket head bolt that is threaded into pivot bracket.
• Tilt belt assembly to desired position. Secure belt assembly
position by tightening socket head bolt in pivot bracket.
• Adjustable positive stops are provided for both horizontal
and vertical positions.
NOTE: The horizontal stops are located on top of the base.
Figure 11 - Belt Assembly Adjustments
ADJUSTING TABLE ANGLE
Refer to Figure 12.
* To adjust table angle, loosen knob, tilt table to desired
position, then secure by tightening knob.
,, Reposition table on support rod to ensure that gap between
table and belt (disc) is _/_6"or less. To reposition table,
loosen bolt, move table on rod and secure in position by
tightening bolt.
Loosen to Change
Position
Figure 12 - Reposition Table when Tilting the Table
HORIZONTAL BELT SANDING WITH WORK STOP
Refer to Figure 13.
,, Remove table assembly and support rod from belt
assembly.
• Tilt belt assembly from vertical to horizontal position and
secure in position.
• Mount work stop to belt assembly using the three screws.
• Idler drum can be used as a contact drum to sand surfaces.
Figure 13 -Attaching the Work Stop
ABRASIVE BELT SANDING
• Finishing flat surfaces: Hold workpiece firmly with both
hands; keep fingers away from abrasive belt.
Use table to position and secure work being sanded. Keep
end butted against table and move work evenly across
abrasive belt.