Unpacking; Assembly; Tools Needed; Mount Sander - Craftsman 351.225930 Operator's Manual

Refer to Figure 1.
Check for shipping damage. If damage has occurred, a claim
must be filled with carrier. Check for completeness.
immediately report missing parts to dealer.
The sander comes assembled as one unit. Additional parts
which need to be fastened to sander, should be located and
accounted for before assembling.
A Sander
B Dust Collection Bag
C Bag Clamp
D Miter Gauge Assembly
E Support Rod
Table Assembly
B
D
Figure I - Unpacking Sander
Refer to Figures 2 - 6.
CAUTION: Do not attempt assembly if parts are missing.
Use this manual to order replacement parts.
WARNING:
Do not operate machine until completely assem-
bled. Do not operate machine until you have completely read
and understood this manual.
TOOLS NEEDED
While assembling or adjusting your belt and disc sander, you
will need the following tools:
• 10mm Wrench
• 5 and 6mm Hex Wrenches
• Combination Square
• Phillips Screwdriver
MOUNT SANDER
Refer to Figure 2.
NOTE: Although compact, the sander is heavy. At least two
people are required to lift from carton.
Choose a suitable location to mount the sander. The sander
must be installed in a place with ample lighting and correct
power supply. To install sander:
• The sander must be bolted to a firm, level surface.
• Make sure there is plenty of room for moving the work-
piece. There must be enough room that neither operators
nor bystanders will have to stand in line with the wood
while using the tool. Allow room so that belt assembly can
be positioned horizontally.
° Sander can be installed on a workbench or a tool stand
/
(see Recommended Accessories, page 15) using bolts,
lock washers and hex nuts (not supplied).
° Figure 2 shows the base dimensions, mounting holes and
required space to allow for table assembly and belt
assembly in horizontal position.
_147/J'_
....................... 15%" ......................
r_ 24"
Figure 2 - Base Dimension and Required Space
ATTACH TABLE ASSEMBLY
Refer to Figures 3 and 4, page 4.
The included table assembly is used with both the disc and
belt.
To use the table with the disc:
• Insert table support rod into sander base. Secure using bolt
(A), make sure bolt tightens onto the flat surface of the rod.
• Position table assembly on support rod so that gap
between table and disc is _/_J' or less. Secure table in
position with bolt (B).
° Loosen knob. Using a combination square, set the table
perpendicular to the disc, and secure in position. If
necessary, set pointer at 0 °.
Bolt (B)
Figure 3 - Using Table with Disc