Advertisement
Available languages
Available languages
INFRARED
SIGNAL TRANSMITTER
WINDOW
CLOCK
TI M E R START/STO P
ONE-TIME/DAILY
INDICATORS
MODE BUTTON
OPERATION
MODE INDICATORS
-
COOLING,
FAN, HEATING,
DEHUMIDIFICATION
AUTO
FAN INDICATORS
-
LOW, MEDIUM, HIGH, AUTO
TIMER SET BUTTONS*
SLIDE DOWN PANEL
i
SENSOR
INDICATOR
--
LOW BATTERY
INDICATOR
UP/DOWN BUTTON
SENSOR ACTIVE
INDICATOR
SWEEP
INDICATOR
ON/OFF
BUTTON
ROOM TEMPERATURE
BUTTON*
BUTTON*
LOCAL SENSING
BUTTON*
*Buttons located behind slide down panel.
Fig. 4-
Remote Control
PROGRAMMING
TIME PERIODS
The duct t}ee sys-
tem can be pr%malrnned to operate at desired levels. Be sure to
set the clock before pro malrnning the system.
• Increments of time are in 10-minute intervals.
• The Timer Start/Stop indicator light on the unit is on
when a time period is set. See Fig. 4.
• The remote control displays the Start/Stop time of the
time period that is closest to the current time. If the unit
is ON, "STOP" and the time period is displayed. If the
unit is OFF, "START" and the time period is displayed.
IMPORTANT: Be sure to point the remote control
]
toward the unit ,ahite pressing the TIMER or SET
I
buttons.
Setting Start/Stop Time
Timer t}ature is used to set unit
operation Start/Stop times. Three different time periods up to
10 hours apart and within 24 hours can be progralrnned using
this feature.
1. Slide down fiont cover of controller below ON/OFF but-
ton. See Fig. 4.
Fig. 5 -- Location of Clock Set Button
on Remote Control
Advertisement
