Carrier EACAAXCC0014 Installation And Operation Manual page 22

INSTALLATION
!. CAUTION: Only a trained experienced serviceman should
_all this electronic air cleaner. The power supply should be
'_removed before installation. To remove the power supply, remove
I the two (2) screws (See Figure 7) in the top front of the cabinet.
] Remember to keep this hardware for reinstallation of the power
supply when the air cleaner installation is complete. A thorough
I checkout of the unit installation should be completed before unit
! operation.
PHYSICAL INSTALLATION OF THE AIR CLEANER
This Electronic Air Cleaner can be installed in any position, except with the
access door facing down. The section entitled TYPICAL MOUNTING
POSITIONS show examples of proper air cleaner mounting with a variety of
furnace installations.
Prior to installing this product...
1. Read rules and instructions carefully for safe operation. Failure to follow
them could damage the product or cause a hazardous condition.
2, Check the ratings given on the product to make sure it is suitable for your
application.
3. Select a location for the air cleaner.
4. Remove the old furnace filter and discard.
5. The air cleaner cannot remove existing dirt from the blower and ducts.
Clean the area thoroughly before you begin.
6. Remove unit access panel, and slide the prefilters and ionizing-collecting
ceils out of the cabinet. Place them safely aside with the warranty and
registration card.
NOTE: The following is a typical installation of the air cleaner on a
highboy furnace. You may have to alter the installation to fit your
particular application.
2O
b
I