Prepare The Hood; Install The Hood - Broan APE1 Series Instructions Manual

APE1 SERIES
Page 3
PREPARE THE HOOD
I I I
I
I I
ALUMINUM
FILTERS
,,
WIRING
COVER
Remove the Aluminum Filters Bottom Cover
Wiring Cover from the hood.
and
t VERTICAL DISCHARGE POSITION
HORIZONTAL DISCHARGE POSITION
BLOWER
-- _.---_'-,. I _ MOUNTING
El
Blower is shipped in Vertical Discharge Position.
To change blower to Horizontal Discharge Position:
Remove Knurled Nuts from Blower Mounting Rods.
Disengage mounting rods from blower and rotate blower
to horizontal discharge position. Re-engage mounting
rods and tighten blower in place with knurled nuts.
DAMPER /
DUCT
CONNECTOR
I
T
VERTICAL DUCT
KNOCKOUT
//
/
HORIZONTAL DUCT
/
• " KNOCKOUT
El Remove Vertical Duct Knockout or Horizontal Duct
Knockout and attach Damper / Duct Connector with
two (2) screws (supplied).
INSTALL THE HOOD
_llb ARNING
To reduce the risk of electrical shock, switch power off
at service panel. Lock or tag service panel to prevent
power from being switched on accidentally.
MOUNTING HOUSE
SCREWS (4) POWER
J 0 © CABLE
" / Itl
.' //qY
)
DUCTWORK
i
El Run House Power Cable between service and
panel
hood location. Attach power cable to hood using appropri-
ate connector.
Hold the hood in position under the cabinet. Make sure
the damper / duct connector enters the Ductwork and
that the damper opens and closes freely.
Tighten the four (4) Mounting Screws completely to se-
cure the hood to the cabinet.