Broan APE1 Series Instructions Manual

Professional style range hood
Hide thumbs Also See for APE1 Series:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

APE1
SERIES
Page 1
P
A
E
GE
I
HOO
AL STYLE
FOR DOMESTIC
COOKING
ONLY
WAR.I.G
WAR.I.G
TO REDUCETHE
RISK OF FIRE, ELECTRIC SHOCK, OR IN=
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufac-
turer. If you have questions, contact the manufacturer at the
address or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel. Lock or tag service panel to prevent power from being
switched on accidentally.
3. Installation work and electrical wiring (including switch loca-
tion) must be done by a qualified person(s) in accordance
with all applicable codes and standards, including fire-rated
construction.
4. Provide sufficient air for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting.
Follow the combustion
equipment
standards such as those published by the National Fire Pro-
tection Association
(NFPA), the American Society for Heat-
ing, Refrigeration and Air Conditioning Engineers (ASHRAE),
and local codes.
5. This product may have sharp edges. Be careful to avoid cuts
and abrasions during installation and cleaning.
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. Use only metal ductwork.
9. As an alternative, this product may be installed with the UL-
approved cord kit designated
for the product, following in-
structions packed with the cord kit.
10.This unit must be grounded.
TO REDUCETHE
RISK OFA RANGETOP
GREASE FIRE:
1. Never
leave surface
units
unattended
at high settings.
Boilovers cause smoking and greasy spillovers that may ig-
nite. Heat oils slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when
flambeing food (i.e. Crepes Suzette, Cherries Jubilee, Pep-
percorn Beef Flambe).
3. Clean ventilating fans frequently. Grease should not be al-
lowed to accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for
the size of the surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS
IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING:*
1. SMOTHER
FLAMES with a close-fitting
lid, cookie sheet,
or metal tray, then turn off the burner. BE CAREFUL TO
PREVENT BURNS. If the flames do not go out immediately,
EVACUATE AND CALLTHE
FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN --You
may be burned or
spread the fire.
3. DO NOT USE WATER, including wet dishcloths or towels -
violent steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher
and you
already know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Fire Safety Tips" published by NFPA.
CAUTION
1. For indoor use only.
2. For general ventilating use only. Do not use to exhaust haz-
ardous or explosive materials and vapors.
3. For best capture of cooking impurities, range hood should be
mounted so that the bottom of the hood is 18"-24" above the
cooking surface.
4. Read specification
label on product for information and re-
quirements.
_
These instructions are for ducted installations only.
If hood is to be installed non-ducted:
Purchase a non-ducted filter kit from your local distributor or
retailer. Follow instructions included with the non-ducted kit.
Conversion to non-ducted nullifies ENERGY STAR<e qualification.
-
Register your product online at:www.broan.com/register
-
Installer: Leavethis manualwiththe homeowner.
Homeowner: C leaning, Maintenanceand Operatinginstructions o n page2.

Advertisement

Table of Contents
loading

Summary of Contents for Broan APE1 Series

  • Page 1 Conversion to non-ducted nullifies ENERGY STAR<e qualification. 4. Use proper pan size. Always use cookware appropriate for the size of the surface element. Register your product online at:www.broan.com/register Installer: Leavethis manualwiththe homeowner. Homeowner: C leaning, Maintenanceand Operatinginstructions o n page2.
  • Page 2: Maintenance

    APE1 SERIES Page 2 CLEANING & MAINTENANCE PREPARE HOOD LOCATION For performance, appearance, and health reasons, clean filter, ROOF CAP fan and grease-laden surfaces. Use only a clean cloth and mild 3%"X 10" detergent solution on stainless and painted surfaces. Clean all- (For vertical metal filters in the dishwasher.
  • Page 3: Prepare The Hood

    APE1 SERIES Page 3 PREPARE THE HOOD DAMPER / DUCT CONNECTOR VERTICAL DUCT KNOCKOUT ALUMINUM FILTERS HORIZONTAL DUCT • " KNOCKOUT WIRING Remove Vertical Duct Knockout or Horizontal Duct COVER Knockout and attach Damper / Duct Connector with two (2) screws (supplied). Remove the Aluminum Filters Bottom...
  • Page 4: Complete Installation

    APE1 SERIES Page 4 CONNECT THE WiRiNG LAMP GREEN GROUND SCREW LAMP BASE HOUSE POWER CABLE range Connect House Power Cable to hood wiring - BLACK to BLACK, WHITE to WHITE, and GREEN CAUTION: Bulb may be hot! Refer to packaging for BARE WIRE to GREEN Ground Screw.
  • Page 5: Service Parts

    APE1 SERIES Page 5 SERVICE PARTS KEY NO, PART NO, DESCRIPTION Feature Panel Weldment - Silver 97018487 Bottom Cover - Silver 97007631 97017429 Damper Assembly 97007656 Wire Cover Assembly 97017428 Thermostat Bracket Assembly 98006546 Light Socket Cover 99400084 Bushing Split Heyco #2873 99010348 Filter, Aluminum (Qty.
  • Page 6 Conversion de non raccordes annule homologation ENERGY STAR @. 4. Utilisez des casseroles de dimension appropri6e. Utilisez toujours une batterie de cuisine adaptee b, la dimension de la surface Enregistrez votre produit en ligne & : www.fr.broan.ca!register chauffante. Installateur"Veuiilezremettrece manuel au propri6taire. Propri6taire" Nettoyage,entretienet mode d'empioi ia page7.
  • Page 7: Nettoyage Et Entretien

    SERIE APE1 Page 7 NETTOYAGE ET ENTRETIEN PREPARATION DE L'EMPLACEMENT DE LA HOTTE Pour des raisons de sante, de performance et d'apparence, nettoyez le filtre, le ventilateur et les surfaces graisseuses. Utilisez seulement chiffon propre et une solution de detergent doux sur I'acier inoxydable et les surfaces peintes.
  • Page 8 SERIE APE1 Page 8 CONDUIT HORIZONTAL CALES DE BOIS POSITION D'EVACUATION VERTICALE 8,3 X 25,4 CM (3-1/4 X 10 PO. (armoires a dessous encastre seulement) TIGE MONTAGE DU AVANT DE L'ARMOIRE 1,9cm(3/4 po.) _:2--_o: _VENTILATEUR o,3cm(1/spo.) Ll__|_____/ TROOLOR CO.DUT.ORJZO.TAL DESSOUS ...
  • Page 9: Installation De La Hotte

    SERIE APE1 Page 9 iNSTALLATiON DE LA HOTTE REIVIPLACEIVlENT DE LAIVIPOULE AVERTISSEIVlENT Pour reduire les risques de choc electrique, coupez le courant du panneau electrique. VerrouJllez ou posez un sceau sur le panneau afin d'eviter que le courant ne soit retabli accidentel- lement.
  • Page 10: Pii=Ces De Rechange

    ® S_:RIE APE1 Page 10 fI_LEU!E LAM PE FLUORESCENTE Remplacez les lampes. Utilisez une larnpe fluorescente de 42 W de type GX24Q-4 et incliner la lampe vers le FENTE haut dans la position. Pour la veilleuse, utilisez une lampe C-7 de 4 watts. Placez le bord avant de la lentille dans la fente.
  • Page 11 Registre su producto en linea en: www.broan.com/register superficie. Avisoal instalador:Deje este manual con el duenode la casa. Avisoal duenode la casa:Enla p gina 12 encontrar las instrucciones de limpieza,...
  • Page 12: Limpieza Y Mantenimiento

    SERIE APE1 P4gina LIMPIEZA Y MANTENIMIENTO PREPARE EL LUGAR DONDE SE VA A INSTALARLA CAIVIPANA Por motivos de desempeffo, apariencia y salud, limpie el filtro, el ventilador y las superficies que tengan grasa. Utilice unicamente un trapo limpio y una soluci6n de detergente suave en superficies de acero inoxidable CONDUCTO...
  • Page 13 SERIE APE1 P_gina 3 1_ PULG. X 10 PULG. (98,3 X 25,4 CM POSICION DE DESCARGAVERTICAL CONDUCTO HORIZONTAL VARILLA CUKIAS DE MADERA MONTAJE (solo gabinetes %.'J_'_----o:". VENTILADOR fondo empotrado) FRENTE 3/4pulg. GABINETE (1,9 cm) MOLETEADA (9,8 cm) I PARACONDUCfO HORIZONTAL | FONDO JL | .,,_6 '/4 pulg .1.6...
  • Page 14 SERIE APE1 P4gina REEMPLAZO DE LA L/_MPARA INSTALE LA CAMPANA 41_i ADVERTENCIA Para reducir el riesgo de una descarga electrica, desconecte el suministro electrico al panel de servicio. Bloquee el panel de servicio o p6ngale una etiqueta de seguridad para evitar LENTE que alguien conecte accidentalmente la energia electrica.
  • Page 15: Piezas De Repuesto

    SERIE APE1 P4gina L_,MPARA FLUORESCENTE Reemplace las lamparas. Usa una Ib, m para fluorescente de 42 W de tipo GX24Q-4 y inclinar la Ib, m para hasta la RANURA posici6n. Para la I_.mpara de noche, utilice una bombilla C-7 de 4 W. PIEZAS DE REPUESTO Coloque el borde delantero de la lente de la lampara en la...
  • Page 16: Warranty

    ORFITNESS FORA PARTICULAR PURPOSE. During this one-yearperiod,Broan-NuTone will, at its option, repair or replace,without charge,any product or part which is found to be defectiveunder normal use and service. THISWARRANTYDOESNOTEXTEND TO FLUORESCENT LAMPSTARTERS, TUBES,HALOGEN AND INCANDESCENT BULBS,FUSES, F ILTERS, D UCTS, R OOFCAPS,WALL CAPS AND OTHER ACCESSORIES FORDUCTING.

Table of Contents