Dimensions; Installation Area - Bosch Vision 800 Series Operating, Care And Installation Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Theaccessory partsbagcontains:
1.Covers t obeplaced overtheholes
forthetransport bolts(after
removing t hetransport bolts
during washer i nstallation).
2.Wrench forleveling.
3.Clamp fordrain hose.
Onthe backofthe washer:
1.power cordwithplug
2.hotandcoldwaterconnections
3. 4 shipping b olts
Usefultools
Thefollowing t oolsarehelpful:
1.Flathead screwdriver.
2.Socket w rench13 m m
3.Closed wrench 13mm
DONOT pushagainst thewasher
doorglass.Risk ofbreakage!
Dimensions
Do not
push against
the door glass!
a = 27.0 in. (68.7 cm)
b = 29.7 in. (75.4 cm)
c = 36.8 in. (93.5 cm) (minimum)*
37.8 in. (96.2 cm) (maximum)*
d = 20.7 in. (52.5 cm)
e = 49.8 in. (126.3 cm)
* height of appliance depends upon
extension of height adjustable feet.
Minimum height is with feet turned all
the way in, against the bottom of the
washer. Maximum height is with feet
extended as far as permitted (must
leave thread of screw engaged
enough for foot to be stable (1/4 inch /
6.4 mm) when extended).
Door opening angle 160 °
Approx. weight = 220 Ibs (100 kg)
Installation
area
Never ground the washer to plastic
plumbing lines, gas lines or hot
water pipes.
This appliance
must be installed on
a solid floor and well leveled due to
the higher spin speeds available.
If
installing the machine on a wood
floor over a basement or on a
second floor, the floor may need to
be reinforced.
Sound, vibration,
and
risk of the washer "walking"
will be
influenced
by the structure and
stability of the floor surface where
the appliance
is installed.
Soft floor surfaces, such as
carpets or surfaces with foam
backing, are not suitable. If
possible, place the washing
machine in a corner of the room.
If the washing machine is to be installed
on a weak wood floor, consider the
following:
Screw a section of water resistant
plywood (at least 3/4" thick) to the
floor. The plywood _hould be
sized to fit the footprint of the
washer, approximately 27" wide x
29.7" deep, or 54" wide x 29.7"
deep to extend underneath both
the washer and the dryer for best
results and even height of the
appliances.
Secure the feet of the washing
machine with holding brackets.
Order the holding brackets (set)
from Bosch Customer Service
(WMZ 2200).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents