Start Dishwasher; Delay Start; Cancel/Interrupt Cycle; Cycle Completion Signal - Bosch SHX33R55UC/64 Use & Care Manual

Operating the Dishwasher
Start the dishwasher:
1 Open the door and press the On/Off button.
2 Select a cycle and desired options.
3 Close the door to begin the cycle.
Delay start (model dependent):
1 Open the door and press the On/Off button.
2 Select a cycle.
3 Press and hold the Delay Start button. Release when the desired delay time is shown in the dis-
play window.
4 Close the door to begin the cycle.
Cancel a cycle:
1 Open the dishwasher door just far enough to expose the control panel. Be careful of hot water that
may splash out.
2 Press and hold the two Cancel/Reset buttons for 3 seconds.
3 Close the door and wait approximately 1 minute until the dishwasher completes the cycle.
4 0 the door and the On button You now start a new ,cle.
CAREFULLY during any wash or rinse cycle. Do not fully open the door until water noises have sto
Interrupt a cycle:
1 Open the dishwasher door just far enough to expose the controls panel. Be careful of hot water that
may splash out.
2 Press the On/Off button to turn the unit off.
3 Wait at least 10 seconds before fully opening the dishwasher door.
4 To resume the cycle, press the On/Off button and close the dishwasher door.
Cycle completion signal:
The cycle completion signal alerts you when a cycle completes and the dishwasher has waashed and
dried the dishes. You can choose to disable the tone or adjust the volume.
To activate:
1 With the unit OFF, press and hold the_ofthe two Cancel/Reset buttons and then press and hold
the On/Off button.
2 When the light on the Cancel/Reset button you are pressing illuminates and the tone goes off,
release both buttons.
3 Press the_of the two Cancel/Reset buttons again until you achieve the desired volume or until
there is no tone (to turn cycle completion signal OFF).
4 Press the On/Off button to save the setting.
15