Remote Installation (Optional) - Thermador VCIB36JP Installation Manual

Remote Control Installation
NOTE: When using the Custom Insert with remote the unit
loses the "AUTO" function and the over-temperature heat
sensor described in the Use & Care Guide.
It is recommended that the Remote Control be wired to the
hood after the hood is installed.
1. Access wiring
a) Remove filters, spacers and grease trays.
b) Remove the junction box cover (refer to Figure 5
on page 11).
c) Remove three screws holding stainless steel panel
to canopy.
Figure 12: Remove stainless steel panel
d) Remove core partition (Figure 13).
Figure 13: Remove core partition
(optional)
2. Connecting the harness to the relay board
a) Insert remote harness end into the mounting hole,
as indicated in Figure 14, until it clicks.
Figure 14: Remote Harness Mounting Hole
b) Run harness through core partition hole
(Figure 15).
Figure 15: Wire Routing through Partition
c) Unplug harness from the remote control to the
relay board (Figure 16).
English 15