Thermador VCIB36JP Installation Manual page 23

VCINxxJP Installation
Procedure
To avoid electrical shock hazard, before installing, switch
power off at the service panel and lock the panel to
prevent the power from being switched on accidentally.
The hood weighs at least 60 lbs; therefore, it
requires at least two people to lift it safely.
Hidden surfaces may have sharp edges.
Use caution when handling the appliance.
Failure to do so may result in property
damage or personal injury.
1. Turn power OFF at the service panel. Lock service
panel to prevent power from being turned ON.
2. Prepare ductwork
a) Refer to "Ductwork Preparation" on page 7.
b) Install metal transition with backdraft damper so
that the flap opens up toward the ceiling. If
necessary, install thermal break and additional
backdraft damper (refer to "Assembly of the
Transition" on page 9).
3. Build housing framework
a) Refer to "General Information" on page 4 for the
applicable model dimensions.
b) Refer to "Installation Preparation" on page 6 for
clearance specifications.
c) Build housing framework for applicable model
according to dimensions in "Preparing VCINxxJP
Housing Framework" beginning on page 18.
4. Install blower motor
a) Refer to "Choosing the Correct Blower" on
page 10.
b) Refer to "Blower Motor Installation" beginning on
page 11.
WARNING:
CAUTION:
5. Install hood trim
a) Hold trim flush to the bottom of the housing.
Secure the trim to the hood with eighteen (18) x ½"
(12.7 mm) screws, as indicated in Figure 25.
6. Install the unit
a) Install the custom insert inside the custom hood.
b) Secure to the rear of the housing framework using
six (6) x 2" (50.8 mm) mounting screws, as
indicated in Figure 26.
Figure 25: VCIN Trim Installation
Figure 26: VCIN Rear Screws
English 21