Status Read Command; Format; Transfer Example; Operation Requirements - Sanyo PLC-WTC500AL - 5000 Lumens Manual

PLC-WTC500L Basic Serial Command Functional Specifications
7

Status Read Command

7.1 Format

0û
PC issues a command in the following format.
"CR" Command [CR]
Command: one character (See Status Read Command Table)
0û When projector receives an appropriate command, it returns the required data in string.
Required Data [CR]
Required Data: string (See Status Read Command Table)
0û When the received data cannot be decoded, the projector returns "?" [CR] is returned.

7.2 Transfer Example

Getting Input mode information of projector by basic commands.
PC ! ' Projector
Projector ! '

7.3 Operation Requirements

When Standby mode of Setting menu is set to Eco and Projector status is Standby mode, Functional
execution commands become invalid
7.4 Status Read Command
Command "CR0" [CR]
Detail Get the projector's operating status
Acceptable
Response
Unacceptable
Command (issue current input mode command)
"C" "R"
PC
"%1" [CR]
"00" = Power ON
"80" = Standby
"40" = Countdown in process
"20" = Cooling Down in process
"10" = Power Failure
"28" = Cooling Down in process due to Abnormal Temperature
"88" = Standby after Cooling Down due to Abnormal Temperature
%1 "24" = Power-Save Cooling Down in process
"04" = Power Save
"21" = Cooling Down in process after OFF due to Lamp Failure
"81" = Standby after Cooling Down due to Lamp Failure
"2C" = Cooling Down in process after Power Off due to
Shutter management
"8C" = Standby after Cooling Down due to
Shutter management
"?" [CR]
20/25
"1" CR
! • ! ' Response
(A few )
ms ÿ ^ 5 s
(Indicating Computer 1 is selected)
"1" CR