Repair Parts Illustration - American Water Heater Ultra Low Nox Gas Water Heater with the Flame Guard Safety System Installation And Use Manual

REPAIR PARTS ILLUSTRATION
When ordering repair parts always give the following
information:
1. Model, serial, and product number
2. Type of gas
3. Item number
4. Parts description
Repair Parts List
Item
Parts Description
No.
1 DRAFT HOOD
2 REDUCER RING - SOME MODELS
3 FLUE BAFFLE
4 HEAT TRAP (COLD) - SOME MODELS
5 HEAT TRAP (HOT) - SOME MODELS
6 COLD WATER DIP TUBE
7 ANODE ROD •
8 TEMPERATURE & PRESSURE RELIEF VALVE •
(LOCATED TOP OR SIDE)
9 DRAIN VALVE
10 GAS CONTROL VALVE/TH ERMOSTAT -_
10 CONTROL MODULE
11 OUTER DOOR
12" PILOT/THERMOPILE ASSEMBLY KIT "_
13" BURNER DOOR ASSEMBLY "_
(Natural Gas/Low Nox)
14" MANIFOLD COMPONENT BLOCK "_
15" BURNER DOOR GASKET
16" VIEWPORT ASSEMBLY "_
17" FLEXIBLE MANIFOLD TUBE "_
18" TEMPERATURE SENSOR "k
19" THERMOPILE y_-
*Pictured on next page.
/
LEGEND
• Special anode rod (see page 21)
Temperature and Pressure Relief Valve is required,
• but may not be factory installed
_r Unique: Flame Guard
TM
Safety System parts
3O