Repair Parts Illustration - American Water Heater Flame Guard Safety System Installation Instructions And User Manual

REPAIR PARTS ILLUSTRATION

When ordering repair parts always give the following
information:
1. Model, serial, and product number
2. Type of gas
3. Item number
4. Parts description
Repair Parts List
Item
Parts Description
No.
1 DRAFTHOOD
2 REDUCER RING - SOME MODELS
3 FLUE BAFFLE
4 HEAT TRAP (COLD) - SOME MODELS
5 HEAT TRAP (HOT) - SOME MODELS
6 COLD WATER DIP TUBE
7 ANODE ROD
8 TEMPERATURE & PRESSURE RELIEF VALVE
(LOCATED TOP OR SIDE)
9 DRAIN VALVE
10 GAS VALVE/THERMOSTAT
11 PILOT ASSEMBLY/THERMOCOUPLE KIT
(Natural Gas)
12 PILOT ASSEMBLY/THERMOCOUPLE KIT
(L.P. Gas)
13 OUTER DOOR
14
BURNER (Natural Gas/Low Nox)
15 BURNER (L.P. Gas)
MANIFOLD DOOR ASSEMBLY (Natural Gas/Low Nox)
16
17 MANIFOLD DOOR ASSEMBLY (L.P. Gas)
18 TWO PIECE WIRE CONNECTOR
WITH RETAINER CLIP
19 MANIFOLD DOOR GASKET
20
VIEWPORT ASSEMBLY
21
THERMOCOUPLE ASSEMBLY (See page 22)
Pictured on next page.
28
Alternate anode
location for top
T & P
Anode location
for side T & P
8
10
LEGEND
5 4
13
Special anode rod (see page 19)
Temperature and Pressure Relief Valve is required,
but may not be factory installed
®
Unique: Flame Guard Safety System parts
1
6
7
9
2
3