Advertisement
Available languages
Available languages
ROUBLESHOOTING
Use FASTER
SPiN
and LONGER
SPiN
options,
Load
is Too
Wet
Try using a high efficiency detergent to reduce sudsing.
at End of Cycle
Load is too small.Very small loads (one or two items) may become unbalanced and not
spin out completely.
Make sure door is firmly closed.
Make sure hose connections
are tight,
Leaks
Water
Make sure end of drain hose is correctly
inserted
and secured
to drain facility.
Avoid overloading.
Use high efficiency
detergent
to prevent
over-sudsing.
Check
fuse or reset circuit
breaken
Straighten
drain hoses. Eliminate kinked hoses,
If there
is a drain restriction,
call for service.
Won*t
Spin
Close the door and push the START/PAUSE
pad. For your safety, washer will not
or Drain
tumble
or spin unless the door is closed.
After pressing
the START/PAUSE pad, it will take 30 seconds
before the washer
begins to
spin.The
door must lock before
spin can be achieved.
See Tub is Completely Full of Suds below.
Plug cord
into live electrical
outlet,
Check
fuse or reset circuit
breaker.
Close
door and push the START/PAUSE
pad to start the washer.
For your safety,
Stops
washer
will not tumble
or spin unless door
is closed.
This may be a pause or soak period
in the cycle, Wait briefly and it may start.
Check
screens
on inlet hoses at the faucets for obstructions.
Clean screens
periodically.
Run the washer
through
another
complete
cycle using cold water.
Tub is Completely
Reduce dete%ent amount for that specific load size, soil level and water hardness.
Full
of Suds
Use high efficiency or low sudsing detergent
specially formulated
for front load washers,
Turn both faucets on fully,
Make sure temperature
selection
is correct,
Make sure hoses are connected
to correct
faucets,
Hush water
lines.
Check
the water
heater.
It should
be set to deliver a minimum
of 120 ° F (49 ° C) hot water
at the tap. Also check water
heater
capacity and recovery
rate.
Fi|ls
with
the
Disconnect
hoses and clean screens. Hose filter screens may be plugged.
Wrong
When
warm
rinse is selected,
only the final rinse will be warm.The
first two
Temperature
rinses will be cold=
Water
As the washer is filling, the water temperature
may change as the automatic temperature
control feature checks incoming water temperature.
This is normal.
While the washer is filling, you may notice just hot and!or just cold water going through the
dispenser when cold or warm wash temperatures are selected. This is a normal function of the
automatic
temperature
control
feature as the washer
determines
the temperature
of the wate_
Cont.
MO
Advertisement
