Advertisement
Available languages
Available languages
Washers can be damaged if water is not removed from hoses
and
internal
components
before
storage.
Prepare
the
washer
for
storage
as
follows:
• Select the COTTON/STURDY
and QUICK
WASH
settings and add one clip of bleach to the detergent
dispenser
without
clothes in the tumbler. Run the washer through a
complete
cycle using hot water.
Turn
the
water
faucets
off and
disconnect
the
inlet
hoses.
Disconnect
the washer
from the electrical
supply and leave
the washer
door open to let air circulate
inside the
tumbler.
If the
washer
has been
stored
in below-freezing
temperatures,
allow
time
for an), water
left over
in the
washer
to thaw
out
prior
to use.
call Maytag
Services_
LLC toU-free
at
1-800-688-9900
USA,
U°S° customers
using
TTY
for
deaf,
hearing
impaired
or speech
impaired,
call
! -800-688-2080.
Washer
door
swing
direction
can
be changed
using
the
following
procedure:
I)
Swing door fully open and support it while removing four hinge screws (which hold hinges to door assembly).
2)
Hove the door to a work surface and transfer four door screws to the opposite side of the door assembly.
3)
Remove one screw holding top hinge to cabinet and one screw holding top hinge cover to cabinet (opposite side).
4)
Remove hinge and bracket from cabinet by moving them up and down to a position
where they are released.
S)
Install hinge and bracket in swapped locations and drive screws to attach them securely to the cabinet.
6)
Compare top hinge and top bracket to bottom
hinge and bottom
bracket for correct
hinge assembly position.
7)
Repeat procedures
4 through 6 for bottom
hinge to cabinet and bottom
bracket to cabinet.
8)
Support door in fully open position on hinge side and drive four screws to securely attach hinges to door assembly.
9)
Close door and check to see that washer operates properly.
Hole
Counter Sunk Screw
_.
_
_
Door
__es
1_))
"-
screws
......
s °°e'ws
9
Advertisement
