Removing Cartridges; Adjusting Surface Burner Low Flame Size - Amana AGDS902 Series Owner's Manual

Smoke Control Grill
TM
Install on right side only.
1. Turn controlsto OFFposition.
2. Remove grillfrom cartridge.
3. Place drip pan in well.
4. Place end of cartridge into range well with air
shutters facing rear of well. Lower front of cartridge
into well.
• Do not tilt cartridge too high. Lifting cartridge over
45 ° can cause damage to orifices.
5. Place grill grate on cartridge.
Grill
Drip pan
Removing Cartridges
1. Turn all controlsto OFF. Make sure cartridge is cool.
2. Using tab on front of cartridge, liftup cartridgeuntil
the bottom clears the range.
• Donottiltcartridgetoohigh. Liftingcartridgeover
45 ° can cause damage to orifices.
3. Pullcartridgetoward the front of range and carefully
lift it out.
Adjusting
Surface Burner Low Flame Size
1. Push and turn burner controlknob to LITEposition.
• Burnersparks until turned from LITE.
2. Set burner control knob to low setting.
3. Removebumercontrolknob.
4. While holding valve stem stationary,turn screw in
center of burner controlstem untilflame is adjusted.
• Use small blade screwdriver.
5. Replace burner controlknob.
6. Turn surface burner control on and offto test burner
flame.
7. Ifflame is adjusted too low, flame may be easily
extinguished. Flame may be extinguishedby drafts,
door opening or closing,heating and coolingvents,
ceilingfans, etc.
Installing Smoke Control Grill
TM
Installing Griddle
1. Turn controls to OFF position.
2. Install cartridgeaccording to "Installing Smoke
Control Grill
TM
Cartridge" section.
3. With grease trap toward rear of range, place griddle
pan over burner.
• To remove griddle cartridgeturn all controlsto OFF
and reverse stepsabove.
Adjusting Low Burner Flame Size
Grease
Trap
Installing Griddle
18