The Oventemperature; Service Tones - Amana ARR629 Use & Care Manual

ADJUSTING THE OVEN TEMPERATURE
HOW TO ADJUST OVEN
TEMPERATURE
The oven has been calibrated at the point of
manufacture. However, if you wish to adjust
the oven temperature to make it bake hotter
or cooler, follow these steps.
To Adjust The Temperature:
1. Push the Bake Temp button once.
2. Turn the TIME/TEMP SET knob clockwise
until an oven temperature greater than
500°F shows in the display.
3. Immediately push and hold the BAKE
TEMP button until "00" appears in the
display (approximately 5 seconds).
.
.
,
To decrease the oven temperature (for
cooler oven): Turn the TIM E/'I'EMP SET
knob clockwise until the negative number
(-05 through -35 in five degree incre-
ments) that represents the °F you wish to
select appears. For example, if you want
to decrease the oven temperature 20°F
you select -20.
To increase the oven temperature (for
hotter oven): Turn TIM E/TEM P SET knob
clockwise past the negative numbers until
the positive numbers (05 through 35 in
five degree increments) appear. Select
the number which represents the °F you
wish to increase the oven temperature.
For example, if you want to increase the
oven temperature 15°F you select 15.
Push SET/CANCEL button to enter this
new oven temperature adjustment. Your
oven bake and broil temperatures are
now adjusted hotter or cooler as you have
selected. This temperature adjustment is
retained, even through power interrup-
tions.
SERVICE TONES
If the oven control sounds a series of short,
rapid beeps and the display shows a diag-
nostic service code (F0-F9) service tone for
over 16 seconds, disconnect the service
breaker and unplug the range. Next, contact
your nearest authorized service person and
indicate which diagnostic service code has
appeared in your display. Each diagnostic
service code indicates which part of the con-
trol or oven needs to be checked by the
service person.
F0- indicates a problem with the CANCEL
button operation.
F1 and F7- indicate a possible short in the
control.
F3, F4, F5, and F8- The service tone will
continue to occur when the oven is used
for bake, broil or olean operations.
F6- the control will not sound a service
tone when this code appears in the
display.
F9- the door lock mechanism needs to be
checked by a service person.
Fd- bake or broil elements need to be
checked by a service person.
Note: If the electronic control should ever
flash through different feature, you have
probably programmed the sales-demo mode.
Press the cancel button to clear the display.
24