GE JGBP86 Owner's Manual & Installation Instructions page 56

Before you call for service...
Troubleshooting tips
Possible" Causes What To Do
Excessive smoking Excessive soil. * Touch tile CLEAR/OFFpad, Open tile windows to
rid tile room of smoke. Wait until tile LOCKEDDOOR
light goes off. Wipe up tile excess soil and reset tile
cleuu cycle.
Oven door will not open Oven too hot. * _dlow tile oven to cool below locking temperature.
aftera clean cycle Do uot lock tile do(n" with tile do(n" latch except wheu
usiug tile sell=clean feature.
Oven not clean after a Oven controls not properly set. * See the Using the self-cleaning upper oven section.
clean cycle
Oven was heavily soiled. * Clean tq) heavv spillove_ before starting tile clean
cycle. Heavily soiled ovens may need
to sell=clean
again, or fin" a longer, l)eri°d of filue.
"Door"appears in the Latch handle was moved to the * Move the latch hamlle to the right Duly wheu setfiug
display (on models fight but a program other than the sell_cleauiug cycle.
with a door latch)
self-clema was selected.
"LOCK DOOR" flashes The self-clem_ cycle has been * ('Jose tile oven door aml on models with a latch, move
in the display selected but the door is not tile latch all tile way to tile right.
closed mad on models with a latch,
the latch was not moved all the
way to the right.
LOCKEDDOOR light The oven door is locked * Touch tile CLEAR/OFF1):1(1. ? dlow tile oven to cool
is on whenyou want because the temperature and then, on models with a door latch, tmhwk tile (loo_:
to cook inside the oven has not
dropped below the
locking temperature.
"F--and a number or On models with a door latch, * Tile latch may have been moved, even if only slightly,
letter"flash in the display if a function error code appears fi'om the locked position. Make sure the latch is moved
during the self-clemahag cycle, to the right as thr as it will go.
check the oven door latch.
Youhave a ftmcfion error code. * Tot/oh the CLEAR/OFFpad.?dlowtheoveutocoollbr
()lie hot/I: PI/t the oveu back lute o})el'atiou.
If the function code repeats. * Disconnect all power to the range for 5 ufiuutes
and then reconnect l)owe_: If tile flmctiou error
code l'epeat_s, call fin" service.
Oven shelves are The nickel shelves (if so equipped) * Apply a small amount of vegetable oil to a paper
difficnltto slide
were cleaned in a self-cleml cycle.
: towel and wipe tile edges of tile oven shelves with
The gray porcelahl-coated shelves tile paper towel. Do not spray with Pare "_or other
(if so equipped) were improperly ltd_ricaut sprays.
cleaned.
"Probe" appears in This is reminding
you to enter a Euter a probe
temperatt/re.
the display (some models) probe temperature after plugging
in the probe.
56