GE JGBP86 Owner's Manual & Installation Instructions page 53

Installation instructions
[] INSTALLING THE ANTI-TIP
DEVICE
A WARNING!
• R'm,,e, _ must be secured with an approxed Anti-
Tip dexice.
• Unless properly installed, the range could be
tipped b) you or a child standing, ,sittin,,_ or
leanino_ on
_lI1 open
door.
• After installing the Anti-Tip dexice, xerili that it
is in place b) careflflly attempting to tilt the
I'll iloe forward.
• This ran,,e has been designed to meet all
recognized industry tip standards for all normal
conditions.
• The use of this de_ice does not preclude tii,)Dim,
of the range when not properly installed.
• If the Anti-Tip de_ice supplied with the range
does not lit this application, use the tmixersal
Anti-Tip dexice X,_ B2X7909.
A. Mark the wall where the RIGHT EDGE of the range
is to be located. Be sm'e to allow fl)r the cotmtertop
overhang if you intend to install the range next to
cabinets.
Slotted head
Marked edge of range
2_ toward the
B. I.ocate the outside edge of the de_ice _ J "
center of the range from the marked edge of the
I'}l I1 re
C. Using the dexice as a template, mark the position of
the hole for the screw.
D. For wood constH/ction, drill a pilot hole at an angle
of 20 degrees from the horizontal. A nail
or awl may
be used if a drill is not a_ailable.
Mount the Anti-Tip de_ice with the screw provided.
For ceulen[ or concrete constitlction, VOtl
will
need
a 1/4" x 1½" lag bolt and a 1/2" O.D. sleeve anchor;
which are not provided. Drill the recommended size
hole tot the hardware.
[] INSTALLING THE ANTI-TIP
DEVICE (CONT.)
Wallboard
Back of range
screw
Install the sleeve anchor into the drilled hole and then
install the lag bolt through tile device. The bolts must
be properly tightened as recommended fin" the
hardware.
E. Slide tile range against the wall, and check for
proper installation by grasping the ti'ont edge of the
cooktop and careflflly attempting to tilt the range
fin'ward.
WHEN ALL HOOKUPS ARE
COMPLETED
Make sure all controls are left in the off position. Make
sure the flow of combustion and ventilation air to the
range is unobstructed.
CONVERTING TO LP GAS (or
converting back to natural gas from LP)
This range leaves the factory set for use with natural
gas. If you want to convert to LP gas, the conversion
must be performed by a qualified LP gas installer,
The come_ion instructions and I,P orifices can be
fotmd attached to the ranoe_ next to the presstu'e
regulator.
Kee I) these instructions and the orifices in case you
_V[lIlt 1o con_.ert back to nattlral gas.
53