Utility; Making Global Settings; Config 1; Utility Making Global Settings - Yamaha PSR-A2000 Owner's Manual

Utility

– Making Global Settings –

CONFIG 1

Call up the operation display.
[FUNCTION] → [I] UTILITY → TAB [E][F] CONFIG 1
Select the desired parameter:
1 Fade In/Out
2 Metronome
3 Parameter Lock
4 Tap
1 Fade In/Out
These parameters determine the behavior when the Style or Song playback is faded in/out by the [FADE
IN/OUT] button.
[3 ▲▼]
FADE IN TIME
[4 ▲▼]
FADE OUT
TIME
[5 ▲▼]
FADE OUT
HOLD TIME
2 Metronome
[2 ▲▼]
VOLUME
[3 ▲▼]–
SOUND
[5 ▲▼]
[6 ▲▼]/
TIME
[7 ▲▼]
SIGNATURE
3 Parameter Lock
This function is used to "lock" specific parameters (effect, split point, etc.) to make them selectable only
via the panel control—in other words, instead of being changed via Registration Memory, One Touch
Setting, Music Finder, or Song and sequence data.
Use the [1 ▲▼]–[7 ▲▼] buttons to select the desired parameter, then lock it with the [8 ▲] (MARK ON)
button. Press the [8 ▼] (MARK OFF) button to unlock.
4 Tap
This allows you to set the drum sound and the velocity which will sound when the Tap function is used.
[2 ▲▼]–
PERCUSSION
[4 ▲▼]
[5 ▲▼]/
VELOCITY
[6 ▲▼]
Determines the time it takes for the volume to fade in, or go from mini-
mum to maximum (range of 0–20.0 seconds).
Determines the time it takes for the volume to fade out, or go from maxi-
mum to minimum (range of 0–20.0 seconds).
Determines the time the volume is held at 0 following the fade out (range
of 0–5.0 seconds).
Determines the level of the metronome sound.
Determines whether a bell accent will be sounded or not at the first beat of
each measure.
Determines the time signature of the metronome sound.
Selects the instrument.
Sets the velocity.
PSR-A2000 Owner's Manual
11
185