Yamaha PSR-A2000 Owner's Manual page 65

4
Press the SONG [■] (STOP) button to stop recording.
A message prompting you to save the recorded performance appears. To close
the message, press the [EXIT] button.
5
Press the SONG [F/ II] (PLAY/PAUSE) button to play back the
recorded performance.
6
Save the recorded performance as a Song.
Press the SONG [SELECT] button to call up the Song Selection display. The
recorded Song can be saved in the Song Selection display. Refer to "Saving
Files" on page 66 for instructions.
Multi Track Recording
A Song consists of 16 separate channels. With this method, you can record
data to each channel independently, one by one. You can also freely change
the channel/part assignments with the Multi Track recording.
The procedure is basically the same as that of "Recording Your Performance"
on page 64, with the following instructions substituted for step 2 above.
While holding down the SONG [REC] button, press the [1 ▲▼] – [8 ▲▼]
buttons to set the desired channels to "REC." Then assign the desired
part to the channel by using the [C]/[D] buttons.
If you want to record the Right 1 part to channel 1, for example, press the
[1 ▲] button while holding down the [REC] button to set the channel 1 to
"REC." Then use the [C]/[D] buttons to select "RIGHT 1."
After proceeding with steps 3 – 5, re-select other channels and record other
parts as desired.
NOTICE
The recorded Song will be lost if
you change to another Song or
you turn the power off without
executing the save operation.
PSR-A2000 Owner's Manual
3
65