Panasonic Viera TX-P42X50B Operating Instructions Manual page 41

Set DVB channel manually [Manual Tuning]
Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial, use this function.
DVB Manual Tuning
Frequency
[CH21]
Signal Quality 0
Signal Strength 0
No. Channel Name
Free TV: 0 Pay TV: 0 Radio: 0
Searching
● All channels found will be added to the Channel List.
Set Analogue channel manually [Manual Tuning]
[Fine Tuning]: Use to make small adjustments to the tuning of an individual programme (affected by weather
conditions, etc.).
[Manual Tuning]: Set Analogue channel manually after Auto Setup.
●
If a VCR is connected only with the RF cable, select channel position [0].
Example:
Analogue Manual Tuning
1 BBC1
Fine Tuning
Manual Tuning 1 99 21
1
Select the channel position
Update DVB channel automatically [Update Channel List]
You can add new channels, delete removed channels, update channel name and position automatically to the channel
list.
Example:
DVB Update Channel List
Progress CH 21
Analogue Scan 21
This will take about 3 minutes.
CH Channel Name
Display a notification message [New Channel Message] (DVB)
Selects whether to give a notification message when a new DVB channel is found.
New channels found!
Press OK to update channel list.
Press EXIT to ignore.
Check DVB signal [Signal Condition]
Selects a channel and checks the DVB signal condition.
A good Signal Strength is not an indication of suitable signal for DVB reception.
Use the Signal Quality indicator as follows.
●
Green bar: Good
●
Yellow bar: Poor
●
Red bar: Bad (Check the Terrestrial aerial)
Example:
DVB Signal Condition
Channel Name 70 CBBC Channel
Signal Quality 0
Signal Strength 0
Bit Error Rate 0.00E+00
Network Name Wenvoe
Frequency 802,00 MHz, 64 QAM, 6940 kS/s
MHz
474
10
select
10
Type New
frequency
search
Data: 0
CH33
41
2
Select the channel
● The channel list is updated while keeping your settings in [Favourites Edit],
68
68 [Channel List], [Child Lock], etc.
●
Depending on the signal condition, the update may not work properly.
Type Quality
● Selecting OK will perform [Update Channel List].
These bars show the maximum signal value of the selected
9
8
channel.
1
Adjust frequency for each channel
select channel
adjust frequency
●
Set where the level of [Signal Quality]
becomes the maximum.
3
Search
●
To change the channel
2
Search
4
Select [Store]
select
store
41