Control Panel - Thermador HMWN30 Use And Care Manual

CONTROL PANEL
Lamp Key On/Off Key - Key Display + Key Delay Key
[e]_l V J [ e]llllll l [41"dl
Pressing "On / Off Key" button once turns blower on. The hood will turn on at level 2
1114 _li'i., II [4 _I¥
Pressing "- key" once from a high speed, turns the blower on low. Each successive press of the +key button
increases the fan speed.The fan cycles stay high until the "- key" is pressed backing to the low speed. The
Display indicates the current fan speed.
This "charcoal filter" option is useful only if the hood is installed in filtering mode. The hood is config-
ured as ducted from the factory.
If it's desireable to install the hood as filtering mode, the filtering accessory needs to be purchased, it
includes the air deflector and the charcoal filters.
To activate a new charcoal filter you need to keep pressed the "key -" and "key +" simultaneously for
three seconds. The charcoal filter is then activated, a "C" will appear in the display and a "beep" will
sound. To deactivate the charcoal filter option, the same procedure needs to be done; also a "C" will be
displayed and a "beep" will sound when it has been deactivated.
After 240 functional hours of the fan operation, charcoals filters must be removed. A "C" will be
displayed (fig a) indicating the charcaol filter saturation, and the filter needs to be changed. To reset the
charcoal filter saturation alarm, press and hold the "Key ON/OFF" for three seconds.
el-" r-*1 ; _1(o7-'I I! illlli:l;g
Eel : l 1:1_'I :IIIIIIIi :I:_
After 40 hours of operation, the grease filters need to be cleaned. Three
horizontal bars, will appears in the display when motor is switched off.
After cleaning, reset the timer, pressing the "0"- Button for three seconds,
then the horizontal bars will disappear. (fig. b)
1!':I_15 IH:WI
This button controls the halogen lighting. The first press turns the lights on.
A second press turns the lights off.
The motor turns on in speed 1 and after 10 minutes is turned off. If Delay button is pressed again,
the motor is turned off. If the button "+"is touched during the timer countdown the delay option is
cancelled and the motor is in the 2nd speed. If the button "-"is touched during the timer countdown
the delay option is cancelled and the motor is turned off.
ID]_II:VIII
fig. a fig. b
Charcoal Filter: Timer Grease Filter: Timer
Indicator. Indicator.
• Continuous use of the fan system while cooking
helps keep the kitchen comfortable and less humid.
• It also reduces cooking odors and soiling
moisture that create a frequent need for cleaning.
• Turn the blower on before starting to cook.
• Use a rear burner when browning or pan frying meat.
• Open a window or inside door slightly.
• Clean the filters and the wall behind the filters frequently.
• The blower should be turned on for a few minutes
before cooking in order to establish air currents
up-ward through the hood. Thus when heat, smoke,
moisture, grease and cooking odors are produced,
they will be carried outside instead of drifting into other
rooms.
• Use the low speeds for normal use and the higher
speeds for strong odors or fumes.
4
Note: Always turn on the hood when using
more than two cooking zones of the range or
when grilling.
• Drafts across the range or cooktop will cause the
escape of heat, smoke, moisture, grease and cooking
odors from the hood. Such drafts should be prevented
in so far as possible.
• The best job of ventilation in the kitchen is done where
the only air currents are those created by the blower itself.
• For Gas Cooktops, a lower blower speed should be
used if."
• The gas flame is being distorted by the
air movement.
• The burner continually sparks (clicks)
• The burner flame repeatedly blows out.