11.11 Main Messages And Their Remedies - Kyocera KM-C2230 User Manual

11

11.11 Main Messages and Their Remedies

Message
Original left on Glass.
Matching paper size is not
available.
Reselect the paper size.
Original size cannot be
detected.
Reselect the paper size.
This mode cannot be set with
the XXXXXX.
The Exit Tray has reached its
capacity.
Input Volume Number and
Access Number using the
numerical Key Pad.
Your account has reached its
maximum allowance.
Close -> Section properly.
Please insert Fusing Unit and
close all doors.
Install the Toner Cartridge, and
then move the lever to the
correct position.
Please insert the Waste Toner
Bottle and close all doors.
Please insert the Image
Transfer Belt Unit and close all
doors.
Replenish paper.
11-70
11.11 Main Messages and Their Remedies
Cause
The document was left on the
original glass.
Paper of a suitable size is not
loaded in a paper drawer.
➀ The document is not
positioned correctly.
➁ A document with a non-
standard size or with a size too
small to be detected is loaded.
Functions that cannot be used
together are selected.
Since the maximum amount of
copies for the indicated finisher
output tray has been exceeded,
the machine is unable to make
copies.
Access number have been
specified. Copies cannot be
made unless an Volume number
and its correct access number
are entered.
The limit on the number of
copies that can be made has
been reached.
Since a machine door or cover is
open or an option is not installed
correctly, the machine is unable
to make copies.
The fusing unit is not installed
correctly.
The indicated toner cartridge is
not installed correctly.
The waste-toner bottle is not
installed correctly.
The image transfer belt unit is
not installed correctly.
The indicated drawer has ran out
of paper.
Remedy
Remove the document from the
original glass.
Either select a different copy
size or manually feed paper of a
suitable size.
➀ Position the document
correctly.
➁ Select the correct paper size.
Make copies using only one of
the functions.
Remove all copies from the
indicated tray.
Enter your Volume number and
access number. (See "Making
Copies With an Account" on
page 6-10.)
Contact your administrator.
Make sure that all doors and
covers are closed and that all
options are installed correctly.
Reinstall the supplies or parts, or
contact your service
representative.
Load paper into the indicated
drawer. (See the corresponding
sections in "Before Making
Copies" on page 2-1.)