Setting up network printing
3.9
Printing with Macintosh
This section describes this machine's settings and the Macintosh network settings.
Specify the printer network port settings after installing the printer driver and when selecting a printer. To
select a printer, refer to "Selecting a printer" on page 2-16.
Operations on this machine
Set the IP address for this machine. For the setting procedure, refer to "Setting the IP address for this
machine" on page 3-3.
Next, specify the AppleTalk or Bonjour settings for this machine as described below.
Note
The settings can also be specified from PageScope Web Connection.
Specifying the AppleTalk settings
When connecting this machine to a Macintosh computer using AppleTalk, the AppleTalk settings must be
specified.
1
Press the [Utility/Counter] key in this machine's control panel, touch [Administrator Settings], and then
enter the administrator password.
–
The administrator password is required to enter Administrator mode. Ask the administrator of this
machine for the administrator password.
2
Touch [Network Settings], then [AppleTalk Settings].
3
Specify settings for the following. After specifying the settings, touch [OK].
–
AppleTalk Setting: Select [ON].
–
Printer Name: Specify the printer name (up to 31 characters).
–
Zone Name: Specify the zone being connected to (up to 31 characters).
4
To apply the settings, restart this machine (turn the main power off, then on again).
Reminder
When turning the power off, then on again, wait at least 10 seconds before turning the power on again;
otherwise, this machine may not function properly.
C650
3
3-29