Konica Minolta bizhub C452 Network Function Manual page 172

9.2 One-Touch/User Box Registration
Item
No.
Name
Fax Number
Line Settings
Index
Icon
bizhub C652/C652DS/C552/C552DS/C452
Description
Press [No], and then enter the registration number of the des-
tination between 1 and 2,000. Press [OK] without entering any
number to register the smallest number available.
Use the touch panel to enter the name to be registered in the
address book using up to 24 characters.
Enter the fax number for the destination using the keypad up
to 38 digits.
• When the PBX connection is enabled and a call is made
from the internal line to the outside line, press [Pause] after
the outside line number such as "0" so that dialing is made
more surely. "P" is displayed on the screen.
• When the PBX connection is enabled, [Outside] is dis-
played on the screen. When you select it, an [E-] is dis-
played.
• If "Confirm Address (Register)" is ON, a screen for entering
the fax number again appears after you press [OK]. Enter
the fax number and then press [OK].
Configure the line that is used to send faxes.
Overseas TX The transmission rate is set to a lower level when having a poor
communication.
ECM OFF Error Correction Mode (ECM) is cancelled to shorten the trans-
mission time.
This is an error correction mode defined by ITU-T (International
Telecommunication Union - Telecommunication Standardiza-
tion Sector). Fax machines equipped with the ECM feature
communicate with each other, confirming that the data sent is
free of errors. Thus, communication can be made free from
disturbances due to line noises, etc.
V34 OFF V34 is a communication mode used for super G3 fax commu-
nication. There are cases when the communication is not pos-
sible in super G3 mode depending on the telephone line
conditions when the recipient's machine or this machine is
connected to the line via a private branch exchange.
In such cases, we recommend that you transmit a fax by se-
lecting V34 OFF to disable the super G3 mode. The V34 mode
is resumed automatically on completion of transmission.
Check Dest. & When sending a fax job, a specified fax number is compared
Send with receiver's fax number information (CSI) and, if they match,
a fax is sent. A mismatch results in a transmission error occurs.
This prevents misdirected transmissions.
• To check the destination and send, the fax number of this
machine must be registered with the recipient's fax ma-
chine.
Select Line If two fax expansion kits are installed, you can select [Line 1]
or [Line 2] to send a fax. Specify the line used for sending fax-
es.
Select the index. For a frequently used destination, specify the
index characters and select [Favorites] at the same time. This
allows you to find it more easily.
Select an icon.
• The selected icon is used for the image panel function that
is available when the optional function code "CAA" is ena-
bled.
d
Reference
For details on the Confirm Address function, refer
to page 10-21.
9
9-9