Set Up Port Triggering - NETGEAR WNDR3800 - N600 WIRELESS DUAL BAND GIGABIT ROUTER-Premium Edition User Manual

N600 Wireless Dual Band Gigabit Router Premium Edition WNDR3800
In the Port Forwarding screen, configure the router to forward the HTTP service to the local
2.
address of your Web server at 192.168.1.33. HTTP (port 80) is the standard protocol for
Web servers.
(Optional) Register a host name with a Dynamic DNS service, and configure your router to
3.
use the name as described in
the Internet, a remote user has to know the IP address that has been assigned by your ISP.
However, if you use a Dynamic DNS service, the remote user can reach your server by a
user-friendly Internet name, such as mynetgear.dyndns.org.

Set Up Port Triggering

Port triggering is a dynamic extension of port forwarding that is useful in these cases:
More than one local computer needs port forwarding for the same application (but not
•
simultaneously).
An application needs to open incoming ports that are different from the outgoing port.
•
When port triggering is enabled, the router monitors outbound traffic looking for a specified
outbound "trigger" port. When the router detects outbound traffic on that port, it remembers
the IP address of the local computer that sent the data. The router then temporarily opens the
specified incoming port or ports, and forwards incoming traffic on the triggered ports to the
triggering computer.
While port forwarding creates a static mapping of a port number or range to a single local
computer, port triggering can dynamically open ports to any computer that needs them and
can close the ports when they are no longer needed.
If you use applications such as multiplayer gaming, peer-to-peer
Note:
connections, real-time communications such as instant messaging,
or remote assistance (a feature in Windows XP), you should also
enable Universal Plug and Play (UPnP) according to the instructions
in
Universal Plug and Play
To set up port triggering, you need to know which inbound ports the application needs. Also,
you need to know the number of the outbound port that will trigger the opening of the inbound
ports. You can usually determine this information by contacting the publisher of the
application or user groups or newsgroups.

To set up port triggering:
Select Advanced > Advanced Setup > Port Forwarding/Port Triggering.
1.
on page 104. To access your Web server from
Dynamic DNS
on page 109.
Advanced Settings
102