How To Change The Key Cd; How To Resume Normal Operation (Esn Security Lock Out); What Happens If An Incorrect Cd Is Inserted - Eclipse CD7200 MKII Owner's Manual

4
Insert the Key CD into the disc slot.
"CANCEL" will be displayed and the
CD will be ejected. ESN is now
deactivated.
ATTENTION
If a CD other than the Key CD is inserted, the
registration cannot be cancelled. In this case,
the "ERR" message is displayed for two
seconds, and the CD playback mode is
activated.
Press the [ e (OPEN/EJECT)]
5
button.
The front panel closes.

How to change the Key CD

1
First, cancel the existing Key CD.
Refer to "How to cancel the Key CD".
2
Next, program a new Key CD.
Refer to "How to program the Key
CD".
How to resume normal operation
(ESN security lock out)
If power is disconnected while ESN security is
active (a Key
operation is disabled until power is restored
and the main unit unlocked. Follow this
procedure to resume normal operation.
When the power is turned on after
the battery power has been
disconnected, the "SEC" message
1
is displayed for two seconds. The
message then changes to the
"DISC" message. Press the [e
(OPEN/EJECT)] button.
CD was programmed),
ESN security operating procedure
2
Insert the Key CD into the disc slot.
"OK" will be displayed for two seconds
and the CD will begin playing.
ATTENTION
• If the incorrect CD is inserted, an "ERR_"
("ERR" and error number) message will
appear for two seconds, after which the CD
will be ejected.
• If "ERR5" (the 5th time an error has
occurred) appears on the display, the
[HELP] message will appear, and the CD
will be ejected. If the "HELP" message
appears, perform the ESN security lock out
operation by following the procedure in
"What happens if an incorrect CD is
inserted?" on page 61.
• You must be use the same CD used for Key
CD programming; a duplicate CD may not
work properly.
What happens if an incorrect CD is
inserted?
After the 5th incorrect attempt, the
1
"HELP" message will be displayed
for five seconds.
"HELP" will
seconds. Then the serial number will
be displayed.
Press the [e (OPEN/EJECT)]
2
button
to close the front panel.
While pressing button [6], press
3
the [SCREEN/TEXT] button, and
hold both for five seconds.
"SEC" will be displayed for two
seconds. Then the six digit rolling code
will be displayed.
be displayed for
X
5
61