Figure 8-12. Port Setup Screen - Eaton POWERWARE 9315 Installation And Operation Manual

8.5.9 Port Setup Screen
Select Port 1 or Port 2 from the Setup menu to display one of the Port Setup screens.
The Port Setup screens allow you to specify settings for the two serial
communication ports on the UPS.
Figure 8-12 shows the Setup Serial Port 1 screen.
UPS System Normal
Alarm: None
Notice: None
Battery
Minutes
48.5
Setup
Port 1
Port 2
Time
Language
Meters
A small return arrow (
the Port Setup screen. This arrow is a reminder that you can press the
pushbutton on the control panel to toggle the scroll bar between the menu box and
the information area. When the scroll bar is in the information area, the return arrow is
in the menu box. When the scroll bar is in the menu box, the return arrow is in the
information area.
When the scroll bar appears in the information area, you can use the pushbuttons to
change the port configuration. To change a setting, press the
to highlight the setting you want to change. To scroll through the available options for
that setting, press the
screen, be sure the Save field is set to YES.
The setup screens for Port 1 and Port 2 are identical. For detailed information about
configuring the serial ports, see Chapter 12, "Communication."
®
EATON Powerware 9315 UPS (500–750 kVA) Installation and Operation Manual
Uninterruptible Power System
MODE
TERMINAL
Events Statistics Graphics

Figure 8-12. Port Setup Screen

) appears in the upper right corner of the information area of
or pushbutton. To save the settings upon exit from this
USING THE CONTROL PANEL
4 MAY 1999
Setup Serial Port 1
RATE DATA/STOP HANDSHAKING
9600 8 1 XON / XOFF
Setup
and
S
164201691 Rev 1 www.powerware.com
09:25:42
SAVE
NO
pushbuttons
8-13