Figure 5-10. Setup Serial Port 1 Screen - Eaton Powerware 9315 Operation Manual

Using the Monitor Panel
Select Port 1 or Port 2 from the Setup menu to display one of the Port Setup screens. The
Port Setup screens allow you to specify settings for the two serial communication ports on
the UPS. Figure 5-10 shows the Setup Serial Port 1 screen.
NOTE
default; the DB-25 is disabled for other uses. Contact your Eaton service representative
to purchase, install, and set up an external modem or an internal X-Slot Modem Card.
UPS System Normal
Alarm:
Notice: None
Battery
Percent
100%
Setup
Port 1
Port 2
Time
Meters
The small return arrow (
This arrow is a reminder that you can press the
the buttons between the menu box and the information area. When the scroll bar is in the
information area, the return arrow is in the menu box. When the scroll bar is in the menu
box, the return arrow is in the information area.
When the scroll bar appears in the information area, you can use the buttons to change
the port configuration. To change a setting, press the
highlight to the setting you want to change. To scroll through the available options for that
setting, press the
the SAVE field is set to YES.
The setup screens for Port 1 and Port 2 are identical. For detailed information about
configuring the serial ports, see Chapter 7, "Communication."
5-12
The X-Slot communication bay is connected internally to the DB-25 port by
Uninterruptible Power System
None
MODE
TERMINAL
Events Statistics Graphics

Figure 5-10. Setup Serial Port 1 Screen

) appears in the upper right corner of the Port Setup screen.
or button. To save the settings upon exit from this screen, be sure
EATON Powerware 9315 UPS (200–300 kVA) Operation Manual S 164201036 Rev F powerware.com
®
04 NOV 1997
Setup Serial Port 1
RATE DATA/STOP HANDSHAKING
9600 8 1 XON / XOFF
Setup
button on the Monitor Panel to toggle
and
14:23:45
SAVE
NO
buttons to move the