Cover Removal - Lenovo Aptiva Hardware Maintenance Manual

Cover removal

To remove top cover:
1. Remove the three cover thumb screws.
2. Slide cover toward the rear of the chassis about
1-Inch (2 cm) to clear the front panel.
3. Lift cover up.
To install top cover:
1. Slide cover down onto the chassis about 1-inch (2
cm) from the front panel.
2. Make sure bottom cover slots are engaged on the
chassis.
3. Slide cover forward to engage the front cover slots
onto the chassis.
4. Install the three cover thumb screws.
72
IBM PC 300/IntelliStation/Aptiva Vol 2 HMM