CD-ROM drive removal
To remove the CD-ROM drive:
1. Remove the top cover.
2. Remove the cables from the CD-ROM drive.
3. Remove two screws securing the CD-ROM drive.
4. Pull the CD-ROM drive out of the chassis.
Note
When connecting the CD-ROM Audio Cable, make
sure the cable is routed along the system board near
the PCI adapter slots. Continue routing the cable
along the system board between the power connector
and primary IDE connector and then up to the
CD-ROM drive. Do not route the CD-ROM cable near
the system board I/O connectors.
PC 300 - 6563/6593/6564/6574 Aptiva - 2178/2198
165