Setting The Items To Recall When Recalling Tracing Memory - Panasonic AWRP120 Operating Instructions Manual

Operating tracing memory (TMEM)
6 .
Press START button [11] .
The tracing memory is recalled and the remote camera starts
moving .
Current recall position
TM 0 3 : 0 m 2 0 s
Re s t o r i n g...
7 .
Operate one of the PAN/TILT lever, ZOOM button,
FOCUS dial, IRIS dial, and white balance mode selection
buttons to make a correction .
Overwriting is performed from the point in time that the correction
operation is performed .
Note
z It is not possible to correct just an arbitrary section of
z
recorded tracing memory data .
The registered data is deleted from the point in time that the
operation is performed so continue the operation until the
recording time ends to register the new data .
8 .
When the recording time elapses, the remote camera
stops automatically .
The process returns to step 3 .
z When STOP button [12] is pressed during recalling, recalling
stops .
The total time of the tracing memory changes, and the process
returns to step 3 .
(continued)
Total time of tracing memory
during recalling
Setting the items to recall when recalling
tracing memory
You can select whether to recall all or only some of the items registered
to tracing memory .
Note
z This function is enabled when AW‑HE50, AW‑HE60, or
z
AW‑HE120 is selected .
1 .
Press the MEM SETTING button .
The current setting appears .
SPEED
SCOPE
z If approximately 3 seconds elapses without an operation being
performed, the previous LCD panel display is redisplayed .
2 .
Turn the F2 dial to select a setting for the "SCOPE" item
from MODE A to MODE C, and then press the F2 dial to
confirm the selection .
The setting of the unit is changed .
This is applied the next time the tracing memory is recalled .
<SCOPE settings and recalled items>
Setting
Pan, tilt, zoom,
and focus
MODE A √
MODE B √
MODE C √
When the operation is performed, the PRESET SCOPE setting of
the remote camera is changed to the same setting as well at the
same time .
⇒ "Setting the operation items for when preset memory is recalled
(PRESET SCOPE)" (page 14)
: ———
: MODE A
Recalled item
White balance
Iris
mode
√ √
√ —
— —
√: Recalled —: Not recalled
21