Setting - Panasonic CZ-RTC6BL Installation Instructions Manual

A protective fi lm is attached on the Control panel.
3
Mount the top case.
● Align the claws of the top
case and then align the
claws of the bottom case.
● If the wiring is difficult to
move, loosen the screw in
the lower case, work on the
wiring, then screw in the
screw after finishing the work.
Avoid the
wire being
caught.
Claw (2 locations)
2
Connect the remote control wiring.
• Be sure not to allow unnecessary wires to remain
in the remote controller case when wiring. Be
careful not to allow wires to be in contact with
parts on the PCB. For connection method, refer
to "Connection to the remote controller terminal
board" in "Attention".

Setting

Preparation: Turn on the circuit breaker of units and then turn the power on. The remote controller starts, and
wait until the [Assigning] display disappears.
(If [Assigning] continues to blink for 10 minutes or more, check the address setting of indoor units.
Refer to indoor/outdoor unit installation details.)
Menu
Language Clock Bluetooth
Steps 1 and 2 are common operations for each item.
1
When stopped
Press .
When operating
Press repeatedly until the menu
screen is displayed.
• To return to the top screen, press
10
Embedded type
1 Mount the bottom case to
the wall.
● Pass the wire through the
wiring hole in the bottom case.
Hole for screw
Claw (2 locations)
Screw
(Supplied)
functionality
®
.
Pass the wire under the rib. Pass the wire under the rib.
• Insert the clamper from the
position indicated by the arrow,
as shown in the diagram at right.
• Put the locking part of the
clamper in the channel as
indicated by the arrow.
• If you lock at the top, it may not
be possible to close the bottom
case.
*It is also possible to mount in the order
2
Select the
item to set.
Press
Remove the coating. Approx. 9 mm
● Make sure the wiring connection
is in the correct direction.
Remote controller
terminal board
Clamper
(supplied)
2 3
→ 1 → .
Total number of items
Number for the
selected item
→ .