Setting The Speed At Which To Move To The Position Set By The Preset Memory; Setting The Operations To Be Performed When A Preset Operation Is Executed; Returning The Remote Cameras To Their Home Position; Adjusting The Panning, Tilting, Zooming And Focusing Speed - Panasonic AW-RP50N Operating Instructions Manual

Setting the functions
 Setting the speed at which to 
move to the position set by the
preset memory
The speed at which to move to the position where the
remote camera has been set to be in the preset memory
when the preset operation is conducted can be set.
From the [SETUP] menu, select [PRESET] and display
[DIAG SPEED]. Then set the speed.
The higher the setting, the faster the operating speed.
1 . D I AG SP E E D
 Setting the operations to be 
performed when a preset
operation is executed
The operations which the remote camera is to performed
when the preset operation is conducted can be set.
From the [SETUP] menu, select [PRESET] and display
[SCOPE]. Then set the operations to be performed.
2 . S C OP E
The operations that the camera performs when a preset
operation is executed differ depending on the mode
selected.
Mode
MODE A Pan, tilt, zoom, focus, iris, gain, white balance
MODE B Pan, tilt, zoom, focus, iris
MODE C Pan, tilt, zoom
Note
This function takes effect when the unit is connected to
the AW-HE50. It does not work with any other models.
▼
1
M O DE A
Operations performed
 Returning the remote cameras 
to their home position
The remote cameras connected can be returned to their
home position.
From the [SETUP] menu, select [PRESET] and display [HOME
POSITION]. Then press the F2 dial.
3. H O M E PO S I T I O N▲
 Adjusting the panning, tilting, 
zooming and focusing speed
The speed is adjusted uniformly for the panning, tilting,
zooming and focusing together.
When the PTZ/FOCUS SPEED dial is turned clockwise,
the speed is increased; conversely, when it is turned
counterclockwise, it is reduced.
1
IRIS AUTO
AUTO
ZOOM
WIDE
From the [SETUP] menu, select [OPERATE] and display
[SPEED TARGET]. If P/T is selected, the speed adjustment is
confined to panning and tilting only.
In this case, the zooming and focusing speed is fixed to the
speed which was set immediately before P/T was selected.
21
S E T
2 3 4 5
CAMERA STATUS / SELECTION
LOW HI
FOCUS/ OTAF PTZ/FOCUS SPEED PAN/TILT
PUSH
PT ACTIVE