Option Menu - Hitachi CP-WUX645N Operating Manual

OPTION Menu

From the OPTION Menu, items shown in the table below
can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor button
on the projector or remote control, or ENTER button on
the remote control to execute the item, except for the
items LAMP TIME and FILTER TIME. Then perform it
according to the following table.
Item
AUTO SEARCH
AUTO
KEYSTONE
AUTO ON
(continued on next page)
Using the ▲/▼ buttons turns on/off the automatic signal search function.
TURN ON TURN OFF
When the TURN ON is selected, detecting no signal automatically
cycles through input ports in the following order. The search is
started from the current port. Then when an input is found, the
projector will stop searching and display the image.
RGB 1 RGB 2
Using the ▲/▼ buttons turns on/off the automatic keystone function.
TURN ON TURN OFF
TURN ON : Automatic keystone distortion correction will be
executed whenever changing the slant of the projector.
TURN OFF : This function is disabled. Please execute the AUTO
KEYSTONE EXECUTE in the SETUP Menu for automatic
keystone distortion correction.
• When the projector is suspended from the ceiling this feature will
not function properly so select the TURN OFF.
• This function will be unavailable when the Transition Detector is
56).
on (
Using the ▲/▼ buttons turns on/off the AUTO ON function.
TURN ON TURN OFF
When set to the TURN ON, the lamp in projector will be
automatically turned on without the usual procedure (
when the projector is supplied with the power after the power was
cut while the lamp was on.
• This function does not work as long as the power has been
supplied to the projector while the lamp is off.
• After turning the lamp on by the AUTO ON function, if neither input
nor operation is detected for about 30 minutes, the projector is
turned off, even though the AUTO OFF function (
Description
HDMI COMPONENT
47
OPTION Menu
S-VIDEO VIDEO
17), only
48) is disabled.