Displaying The Picture; Turning Off The Power - Hitachi CP-WUX645N Operating Manual

Displaying the picture

1. Make sure that the signal source is sending the signal to the
projector.
2. Use the VOLUME +/- buttons to adjust the volume. To have
the projector silent, press the MUTE button on the remote
control.
3. Press the INPUT button on the projector.
Each time you press the button, the projector switches its input
port in turn.
4. Press the ASPECT button on the remote control. Each time
you press the button, the projector switches the mode for
aspect ratio in turn.
5. Use the zoom ring to adjust the screen size.
6. Use the focus ring to focus the picture.
7. Use the vertical lens shift dial to shift the picture upward or
downward. It is recommended to adjust the picture upward.
8. Use the horizontal lens shift dial to shift the picture left or
right.
CAUTION
►If you wish to have a blank screen while the
projector's lamp is on, use the BLANK function. (See
the "Operating Guide" in the CD.) Any other method
of blocking the projection light, such as attaching
something to the lens or placing something in front of
the lens, may cause the damage to the projector.

Turning off the power

1. Press the STANDBY/ON button on the projector or the remote
control.
The message " Power off? " will appear on the screen for about
5 seconds.
2. Press the STANDBY/ON button on the projector or the remote
control again while the message appears.
The projector lamp will go off, and the POWER indicator will
begin blinking in orange.
Then the POWER indicator will stop blinking and light in
steady orange when the lamp cooling is complete.
3. Make sure that the POWER indicator lights in steady orange,
and set the power switch to the OFF position (marked " O ").
The POWER indicator will go off. Attach the lens cover.
Do not turn the projector on for 10 minutes or more after turning it off. Also, do not turn the
projector off shortly after turning it on. Such operations might cause the lamp to malfunction or
shorten the lifetime of some parts including the lamp.
WARNING
►Do not touch around the lamp cover and the exhaust vents during use or just after use,
since it is too hot.
ASPECT
button
MUTE button
1/2
1/10
1/10
STANDBY/ON button
8
INPUT button
LASER
INDICATOR
STANDBY/ON VIDEO RGB
MY SOURCE/
DOC.CAMERA
SEARCH
BLANK LASER
ASPECT
PUSH ENTER
PAGE UP PAGE DOWN
ESC MENU RESET
POSITION AUTO PbyP
MAGNIFY MY BUTTON VOLUME
+
ON 1
OFF 2 -
FREEZE KEYSTONE MUTE
VOLUME +/- buttons
Zoom ring Focus ring
Top
Lens shift cover
POWER indicator
LASER
INDICATOR
STANDBY/ON VIDEO RGB
MY SOURCE/
DOC.CAMERA
SEARCH
BLANK LASER
ASPECT
PUSH ENTER
PAGE UP PAGE DOWN
ESC MENU RESET
POSITION AUTO PbyP
MY BUTTON VOLUME
MAGNIFY
+
ON 1
OFF 2 -
FREEZE KEYSTONE MUTE
Power
switch