1. Read "Safety" on page v and "Handling static-sensitive devices" on page 26.
2. Open the release handle (rotate the handle down).
3. Slide the advanced management module into the advanced management
4. Close the release handle (rotate the handle up).
Installing a power module
To install a power module, open the release handle, slide the power module into
the power module bay, and close the release handle.
Note: On the rear of the power module, there is a plastic strain-relief tie that
should not be removed.
1. Read "Safety" on page v and "Handling static-sensitive devices" on page 26.
42
BladeCenter S Type 7779/8886: Installation and User's Guide
module bay until it stops.
Advanced
management
module
Release handle
Power module
fillers
Power module 3
Power module 4