Table of Contents
Advertisement
4. Close the release handles (rotate the top handle down and the bottom handle
up).
5. Install hard disk drives:
a. Open the release handle on the hard disk drive (rotate the handle up).
b. Slide the hard disk drive into the storage module until it stops.
Important: If SAS connectivity modules are installed in the BladeCenter S
chassis, the drive bay that you use is determined by the SAS connectivity
module zoning configuration that you have selected for the BladeCenter S
system.
If SAS RAID controller modules are installed in the BladeCenter S chassis,
make sure that you install SAS hard disk drives. SATA hard disk drives are
not currently supported when using SAS RAID controller modules.
c. Close the release handle (rotate the handle down).
Chapter 2. Installing the BladeCenter S Types 7779 and 8886
39
Advertisement
Table of Contents
