Table of Contents
Advertisement
1. Open the release handle (rotate the handle down).
2. Slide the battery backup unit into the media tray.
3. Close the release handle (rotate the handle up)
Installing a storage module
To install a storage module, open the release handles on the storage module and
slide the storage module into the storage module bay. Then, you can install hard
disk drives into the storage module by opening the release handle on the hard disk
drive and sliding the hard disk drive into the hard disk drive bay.
Note: Four power modules are required in the BladeCenter S chassis if two storage
modules are installed. If you are installing a storage module in storage module bay
2, you must have power modules installed in power module bays 3 and 4.
Drive
handle
1. Read "Safety" on page v and "Handling static-sensitive devices" on page 26.
2. Open the release handles on the storage module (rotate the top handle up and
3. Slide the storage module into the storage module bay until it stops.
38
BladeCenter S Type 7779/8886: Installation and User's Guide
Battery backup module
Drive
cage
filler
Drive-tray
assembly
the bottom handle down).
Media tray
Battery filler
Filler
panel
Advertisement
Table of Contents
