Table of Contents
Advertisement
Important: Do not place the label on the blade server or in any way block the
ventilation holes on the bezel.
Installing a serial pass-thru module
Install a serial pass-thru module in the rear of the BladeCenter S chassis by
opening the release handle and sliding the serial pass-thru module into the module
bay.
Module
filler
1. Read "Safety" on page v and "Handling static-sensitive devices" on page 26.
2. Open the release handle (rotate the handle down).
3. Slide the module into the serial pass-thru module bay until it stops.
4. Close the release handle (rotate the handle up).
Installing an advanced management module
To install an advanced management module, open the release handle on the
module and slide it into the advanced management module module bay.
Serial
pass-thru
module
Release
handle
Chapter 2. Installing the BladeCenter S Types 7779 and 8886
41
Advertisement
Table of Contents
