Ipv4 Setup Menu Options - Cisco 6921 - Unified IP Phone Standard VoIP Administration Manual

IPv4 Setup Menu Options

IPv4 Setup Menu Options
The IPv4 Setup menu is a submenu of the Network Setup menu. To reach the IPv4 Setup menu, select
the IPv4 option on the Network Setup menu.
Table 4-2
For information about the keys you can use to edit options, see the
Table 4-2 IPv4 Setup Menu Options
Option
DHCP
IP Address
Subnet Mask
Default Router 1
DNS Server 1
Cisco Unified IP Phone 6921, 6941, and 6961 Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP)
4-6
describes the IPv4 Setup menu options.
Description
Indicates whether the phone has DHCP enabled or
disabled.
When DHCP is enabled, the DHCP server assigns the
phone an IPaddress. When DHCP is disabled, the
administrator must manually assign an IP address to the
phone.
Internet Protocol (IP) address of the phone.
If you assign an IP address with this option, you must also
assign a subnet mask and default router. See the Subnet
Mask and Default Router options in this table.
Subnet mask used by the phone.
Default router used by the phone (Default Router 1).
Primary Domain Name System (DNS) server (DNS Server
1) and optional backup DNS servers (DNS Server 2–5)
used by the phone.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
"Editing Values" section on page
To Change
Scroll to the DHCP option, press the
Edit softkey, then press either the No
softkey to disable DHCP, or press the
Yes softkey to enable DHCP.
Set the DHCP option to No.
1.
Scroll to the IP Address option,
2.
press the Edit softkey, and then
enter a new IP Address.
Press the Apply softkey, then
3.
press Save.
Set the DHCP Enabled option to
1.
No.
Scroll to the Subnet Mask
2.
option, press the Edit softkey,
and then enter a new subnet
mask.
3. Press the Apply softkey, then
press Save.
Set the DHCP Enabled option to
1.
No.
2. Scroll to the appropriate Default
Router option, press the Edit
softkey, and then enter a new
router IP address.
Press the Apply softkey, then
3.
press Save.
Set the DHCP Enabled option to
1.
No.
Scroll to the appropriate DNS
2.
Server option, press the Edit
softkey, and then enter a new
DNS server IP address.
3. Press the Apply softkey, then
press Save.
4-3.
OL-19025-01